TP1010C
USB Programmer Driver
Download this first to install your USB
Programmer.
TP1010C
V2.3A Upgrade
Update list:
1. Added NiCd/NiMh/PB(SLA)/A123 battery charge/discharge/Cycler
2. Memory slots(10memory) are independently assigned to the each battery
type.
3. A123 top off voltage is adjusted to 3.65V/cell
4. Added System timeout(it can be selectable to 2-10Hour)
5. The last cycle data of charge and discharge before an error interruption
occurs which can be readable by a
press[Sel] button.
6. Discharge power factor added
7. Added 1's decimal digit to the volatge display.
TP1010C V2.00D Upgrade:
Charge mode for A123 data:
Topoff charge:3.65V
Over voltage error:3.85V
Initaial slow charge to 3.0V
A123 recovory mode: 1.5V
--Discharge voltage minimum 3.0V
How to select A123:
Go to Option->charge setting mode
Press INC key until the LCD displays A123cell charge
mode.
|
TP1010C
Programmer Instructions
Instructions to help you setup your
TP1010C Programmer.
TP1010C
V1.85 UPGRADE
Use this Upgrade to update your 1.85
TP1010C, then upgrade to the most
current version.
TP1010C
V2.1A Upgrade
Charge mode for A123 data:
Topoff Charge: 3.65V
Over voltage error:3.85V
Initaial slow charge to 2.4V
A123 recovory mode: 1.5V
Li-Po Recovery mode: 2.0V
|
